Hot Wheels Ultimate Dual Dragon Transporter 설치 팁

Quick answer

Set up the Hot Wheels Ultimate Dual Dragon Transporter by first assembling the base launcher and dragon track, then attaching the detachable dragon and testing the car-eating action before full play.

Step-by-step setup guide

1. 1. Unbox and lay out all parts: Remove the transporter base, detachable dragon, launcher ramps, and any Hot Wheels cars from the box. Identify the dragon's wing button and the car-eating mouth mechanism. Check that the dragon's mouth opens and closes freely before attaching it.
2. 2. Assemble the base launcher: Connect the launcher ramps to the transporter base as shown in the manual. Ensure the ramps click into place and are level on a flat surface. If the ramps wobble, reposition the base on a hard floor—carpet can cause instability.
3. 3. Attach the detachable dragon: Snap the dragon onto the designated slot on the base. Press down until you hear a click. Confirm the dragon's track section aligns with the launcher exit. The dragon must be fully seated; a loose connection will prevent cars from rolling onto its track.
4. 4. Test the car-eating feature: Place a Hot Wheels car in the dragon's mouth. Press the button to make the wings move and watch the dragon 'eat' the car. Release the car into the launcher. If the car doesn't release, gently tilt the dragon forward to help gravity.
5. 5. Launch and play: Load cars into the launcher and press the trigger. Watch them race through the dragon track and back to the base. Adjust the launcher angle for different speeds. Use standard Hot Wheels cars for best results; wider or heavier cars may get stuck in the dragon's mouth.

Product facts

• Hot Wheels Ultimate Dual Dragon Transporter: The detachable dragon eats toy vehicles and can be transformed into a racetrack. This dual function means you must attach the dragon securely to the base before using it as a track, or cars may derail.

  

• Hot Wheels Ultimate Dual Dragon Transporter: Pressing a button makes the dragon's wings move to emulate a real dragon. The wing button is on the dragon's body; locate it before assembly to avoid accidental activation during setup.